"Customer concern is that dishwasher leaks along of water, not washing properly.rusted rack and broken clip on knife holder. Preformed visual inspection. Found unit completely full of water at time of arrival, caused by stuck open inlet valve. Drained water from unit. Found torn tub seal, causing unit to leak during operation. Also found damaged door sweeper seal, causing leak during operation. Found detergent pod in top rack , advised customer always use detergent dispenser. Found clogged spray arms, causing unit to produce poor wash quality. Cycle tested unit 3x, found leaking sump seal, causing leak from under unit during operation. Needs new upper and lower spray arms, tub seal, sweeper seal, sump seal and inlet valve. Turned off water, advised customer against restoration of water to prevent further leaking under unit and further damage to sub floor. Advised customer sump seal shows NLA. REQUIRES AUTH ; ordrng 1 W10542314 (GASKET) and 1 8268395 (Sump seal) and 1 WP8535083 (ARM-SPRAY) and 1 WP8268332 (ARM-SPRAY) and 1 WP8268937 (INLET-AIR) and 1 WP8531669 (VALVE-INLT)"

"Customer gave permission to preforme repair in the home while customer left for work. Installed new doorlock, door still fails to lock, F92 error no shown. found failed control board and inverter board not communicating causing washer not to operate. Needs new main control board and inverter board. Advised customer inverter currently out of stock and may take time to recive. Requires auth.; ordrng 1 WH22X35518 (MAIN CONTROL BOARD FLW LE W/INSTRUCTIONS) and 1 WH22X35837 (INVERTER BOARD), states that autho needed"

Customer concern is that door is not locking and fabric dispenser is leaving water inside that cup and that door is not locking. Found failed lid lock cause washer not to start cycle. Cleaned debris from dispenser drawer and dispenser. Follow up scheduled for 05/03 8-12pm; ordrng 1 WH01X29528 (DOOR LOCK)

Customer concern is that dishwasher is not powering on. Found no voltage at outlet. Cycled breaker no change. Ran extension to different outlet. Cycle tested dishwasher all checks good. No mechanical or component failures at time of service. Advised customer electrian is needed for power supply issues.

Installed new pcb display no operation. Verified 12v to display. Installed new main pcb. Display is now operational. Cycle tested unit all checks good.