A repair in Sulphur Springs, TX
GE Washer Not Draining: Control Board and Drain Pump Repair in Sulphur Springs
A GE washer in Sulphur Springs was not draining properly. The technician replaced the failed drain pump and main control board, then tested the washer using a rinse and spin cycle. The unit was confirmed to be operating normally at the time of service.
What the customer noticed
The washer would not drain, and the drain pump was not operating.
What we found
Inspection revealed that a burned component on the main control board was preventing it from supplying voltage to the drain pump. The technician's findings also identified a shorted drain pump as the cause of the control board failure.
What we repaired
The technician replaced the drain pump and main control board.
How we checked the result
After the repair, the washer was tested using a rinse and spin cycle. Testing confirmed proper filling, draining, and spinning. The unit was operating properly at the time of service.