A repair in FORNEY, TX
GE washer not draining: inverter board repair in Forney
A GE washer in Forney, TX, was leaving water in the tub after cycles ended prematurely due to a faulty inverter board. The technician replaced the inverter board and tested the washer to confirm proper operation.
What the customer noticed
The customer reported that the washer was not draining properly, leaving water in the tub when cycles ended prematurely.
What we found
Diagnostic testing confirmed that the drain pump was operating properly. However, stored F3 and F46 error codes, along with intermittent basket speed readings, indicated a faulty inverter board affecting cycle operation.
What we repaired
The technician replaced the faulty inverter board using a part from truck stock, then ran and monitored the washer for approximately 15 minutes.
How we checked the result
The washer was tested after the repair, with no additional issues detected at the time of service.