From our technicians
What happened. What we found. What we repaired.
A symptom tells part of the story. Here’s how our technicians found the cause and checked the result on real appliance repairs.
Showing 145 to 156 of 168 repair stories
A Whirlpool washer in Rowlett was starting cycles but not progressing through them properly. The technician repaired and recalibrated the unit, then tested it and confirmed that it was progressing through the cycle normally at the time of service.
Read the repair story →South Hill, WAMaytag range oven not heating and burner stuck: ignitor and valve repair in South HillA Maytag range in South Hill had slow oven heating and a stuck left rear burner knob. Replaced the needed oven ignitors and gas valve, then the burner and both ovens were tested.
Read the repair story →UNIVERSITY PLACE, WAWhirlpool range burner contact and element repair in University PlaceA Whirlpool range in University Place was experiencing surface and oven cooking issues. The technician found worn contacts in the front burner infinite switches and an open front-left center element. The technician replaced the affected parts and tested the range afterward.
Read the repair story →Carrollton, TXMaytag washer stopped mid-cycle in Carrollton: shifter repairA Maytag washer in Carrollton was shutting off into cycle complete early. The technician found a bad shifter, replaced it, and confirmed the washer was working at the time of service.
Read the repair story →Alba, TXGE dryer not heating: vent reconnected in AlbaA GE dryer in Alba was reported tumbling without heat. The vent was found disconnected, then reconnected and the dryer was tested again with heat present.
Read the repair story →Forney, TXSamsung dryer not tumbling: thermostat replacement in ForneyA Samsung dryer in Forney would not tumble. Inspection pointed to a heat-related failure. The dryer was repaired and tested during a follow-up visit.
Read the repair story →Plano, TXMaytag Dryer Not Heating: Heating Element Repair in PlanoA Maytag dryer in Plano was not heating. The technician found a broken heating element coil, replaced the element, and tested the dryer on heat to confirm it was working at the time of service.
Read the repair story →Princeton, TXSamsung refrigerator ice maker noise cleared in PrincetonA Samsung refrigerator in Princeton was reported with a loud ice‑maker noise. The ice maker was inspected, frost buildup was found, the frost was cleared from the crushed/cubed mechanism, and the ice dispenser was tested afterward.
Read the repair story →Gig Harbor, WAGE dishwasher not powering on: L1 connection secured in Gig HarborA GE dishwasher in Gig Harbor would not power on. Inspection found a loose L1 connection. The connection was secured before the unit was cycle tested and confirmed operating at the time of service.
Read the repair story →Allen, TXBosch dishwasher not completing cycles: controller repair in AllenA Bosch dishwasher in Allen was reported as not completing its cycle. Diagnostics pointed to a control issue. A new controller was installed and tested during the visit.
Read the repair story →Southlake, TXKitchenAid dishwasher instability corrected in SouthlakeA KitchenAid dishwasher in Southlake was found unstable and washing poorly. The technician replaced the necessary support components and confirmed the dishwasher was operating properly at the time of service.
Read the repair story →Carrollton, TXGE Microwave Not Heating: Magnetron Repair in CarrolltonA GE microwave in Carrollton was not heating. The technician found a faulty magnetron tube, replaced the part, and tested the microwave at the visit.
Read the repair story →



