What happened. What we found. What we repaired.

A Whirlpool refrigerator in Rockwall was not cooling. The technician found a defrost problem, replaced the noted parts, and verified the unit was cooling before leaving.

A Maytag washer in McKinney would not stop filling. The technician found the water valve stuck open, replaced it, and confirmed the washer was working at the time of service.

An LG microwave in Puyallup was reported to be operating without heating. The technician replaced the faulty high-voltage components and tested the microwave, confirming that it was heating and operating properly at the time of service.

A GE washer in Sulphur Springs was not draining properly. The technician replaced the failed drain pump and main control board, then tested the washer using a rinse and spin cycle. The unit was confirmed to be operating normally at the time of service.

A Whirlpool refrigerator in Sulphur Springs was experiencing an issue with the water dispenser stopping after dispensing only a partial cup of water. The technician replaced the filter housing and tested the dispenser, confirming that water flowed normally after the repair.

A Samsung washer in Carrollton was not spinning clothes properly. Diagnostic testing indicated an issue with the suspension rods. The necessary repairs were completed, and the washer was tested during the final service visit.

A GE washer in Quinlan would not spin the basket normally. Inspection pointed to the inverter board and motor circuit, and the inverter board was replaced before the washer was tested again.

A Maytag washer in Bonney Lake was not draining or finishing cycles. The technician found a worn open wire harness to the drain motor, replaced the harness, and tested the washer afterward.

A Whirlpool washer in Rowlett was starting cycles but not progressing through them properly. The technician repaired and recalibrated the unit, then tested it and confirmed that it was progressing through the cycle normally at the time of service.

A Maytag range in South Hill had slow oven heating and a stuck left rear burner knob. Replaced the needed oven ignitors and gas valve, then the burner and both ovens were tested.

A Whirlpool range in University Place was experiencing surface and oven cooking issues. The technician found worn contacts in the front burner infinite switches and an open front-left center element. The technician replaced the affected parts and tested the range afterward.

A Maytag washer in Carrollton was shutting off into cycle complete early. The technician found a bad shifter, replaced it, and confirmed the washer was working at the time of service.